Kawacut
Request a quote
Toolholding2 min read

Pull studs and drawbars, and the case for checking both

On a BT spindle, the holder is drawn into the taper by its pull stud. The stud screws into the back of the holder, and the spindle’s drawbar grips its head and pulls the taper home. Disc springs in the spindle hold the pull, and the drawbar releases when the tool changer needs the holder.

The head angle

The gripper in the drawbar is made for one head angle, and the pull stud must match it. Kawacut lists 5 pull studs for BT30, BT40 and BT50 spindles, with 45°, 60° and 90° heads. The machine builder’s manual gives the angle.

A stud with the wrong angle may still clamp, but the gripper bears on an edge instead of the full face of the head. Clamping force falls, and the holder can move in the taper under a heavy cut.

Drawbar force

The disc springs lose force over years of tool changes. Low drawbar force shows as chatter and as fretting marks on the holder taper, and it is easy to blame on the tool. A drawbar force gauge, held in the spindle like a holder, gives a reading to compare with the builder’s figure.

What to check

  1. 01Fit pull studs to the torque the holder maker specifies, with clean threads.
  2. 02Inspect the head and neck for wear and cracks, and replace studs on a schedule.
  3. 03Measure drawbar force at each spindle service.

HSK holders have no pull stud. The spindle clamps from inside the hollow taper, so the same checks apply to the clamping set in the spindle instead.

Have the drawbar force on your spindle measured.Book an engineer visit

In this article

Next in the journalWhat a few microns of runout do to a solid carbide end mill
Kawacut

Some assembly required.

Scroll to build a BT40 collet chuck.

01 / 09

BT40 taper

7:24 steep taper. The spindle grips here.

02 / 09

Flange

The V-groove is where the tool changer takes hold.

03 / 09

Drive keys

One each side, so the spindle can turn it.

04 / 09

Pull stud

The drawbar pulls on this. Hard.

05 / 09

ER nose

The body that carries the collet.

06 / 09

Marking

Name on the side, so the setter knows what it is.

07 / 09

ER collet

Slotted from both ends, so it closes evenly on the shank.

08 / 09

End mill

The part that actually does the cutting.

09 / 09

Clamping nut

Torqued down. One BT40 ER collet chuck.

Lol, good try!

Go check the website out on a desktop.

kawacut.com