Kawacut
Request a quote
T01 Toolholders

Special holders

Holders outside the standard families, quoted against the operation and the drawing.

Part numbers
17
In stock
17
Request a quoteNot listed? Send the drawing
Special holders, 17 part numbers
Part numberDescriptionWeightAvailability
BT40-90-20-70BT40 special holder—In stock
BT40-ACH2547-200BT40 special holder—In stock
BT40-D40-300BT40 special holder—In stock
BT40-LBK2-135LBT40 special holder—In stock
BT40-OSL-20BT40 special holder—In stock
BT50-90-20-70BT50 special holder—In stock
BT50-ACH3260-200BT50 special holder—In stock
BT50-ACH3260-250BT50 special holder—In stock
BT50-ACH4174-250BT50 special holder—In stock
BT50-ACH4174-300BT50 special holder—In stock
BT50-ACH4174-350BT50 special holder—In stock
BT50-ACH5395-300BT50 special holder—In stock
BT50-ACH5395-350BT50 special holder—In stock
BT50-ACH5395-400BT50 special holder—In stock
BT50-ACH6815-350BT50 special holder—In stock
BT50-ACH68150-400BT50 special holder—In stock
BT50-D40-300BT50 special holder—In stock
Kawacut

Some assembly required.

Scroll to build a BT40 collet chuck.

01 / 09

BT40 taper

7:24 steep taper. The spindle grips here.

02 / 09

Flange

The V-groove is where the tool changer takes hold.

03 / 09

Drive keys

One each side, so the spindle can turn it.

04 / 09

Pull stud

The drawbar pulls on this. Hard.

05 / 09

ER nose

The body that carries the collet.

06 / 09

Marking

Name on the side, so the setter knows what it is.

07 / 09

ER collet

Slotted from both ends, so it closes evenly on the shank.

08 / 09

End mill

The part that actually does the cutting.

09 / 09

Clamping nut

Torqued down. One BT40 ER collet chuck.

Lol, good try!

Go check the website out on a desktop.

kawacut.com