Kawacut
Request a quote
T04 Machines

End mill grinders

Bench grinders that resharpen end mills on the shop floor. The X8 grinds ball-nose cutters.

Part numbers
7
In stock
7
Request a quoteNot listed? Send the drawing
End mill grinders, 7 part numbers
Part numberDescriptionWeightAvailability
BALL NOSE END MILL GRINDER X8Ball nose end mill grinder X8—In stock
END MILL GRINDER X1End mill grinder X1—In stock
END MILL GRINDER X3End mill grinder X3—In stock
END MILL GRINDER X3AEnd mill grinder X3A—In stock
END MILL GRINDER X3DEnd mill grinder X3D—In stock
END MILL GRINDER X6End mill grinder X6—In stock
END MILL GRINDER X6AEnd mill grinder X6A—In stock
Kawacut

Some assembly required.

Scroll to build a BT40 collet chuck.

01 / 09

BT40 taper

7:24 steep taper. The spindle grips here.

02 / 09

Flange

The V-groove is where the tool changer takes hold.

03 / 09

Drive keys

One each side, so the spindle can turn it.

04 / 09

Pull stud

The drawbar pulls on this. Hard.

05 / 09

ER nose

The body that carries the collet.

06 / 09

Marking

Name on the side, so the setter knows what it is.

07 / 09

ER collet

Slotted from both ends, so it closes evenly on the shank.

08 / 09

End mill

The part that actually does the cutting.

09 / 09

Clamping nut

Torqued down. One BT40 ER collet chuck.

Lol, good try!

Go check the website out on a desktop.

kawacut.com