Kawacut
Request a quote
Collets2 min read

Reading an ER collet: series, clamping range and when to retire one

The ER collet is a common way to hold a round shank in a milling chuck, a drilling holder or a lathe extension. The system was defined in DIN 6499 and is now covered by ISO 15488, so a collet from one maker fits another maker’s chuck of the same size.

The size on the collet

The number after ER names the body size, and with it the nut and the chuck the collet fits. An ER32 collet goes into an ER32 chuck under an ER32 nut, whatever bore it carries. The second number marked on the collet is the bore, in millimetres.

Kawacut’s full ER range runs from ER11 to ER40, 102 collets in all, with half-millimetre steps in ER11.

How far a collet closes

Each collet closes over a short range below its nominal bore: about half a millimetre for the smallest bodies such as ER11, and about a millimetre from ER16 upwards. A 10 mm collet in ER32 will hold a shank between 9 and 10 mm.

The grip is best at the nominal size. A shank at the bottom of the range is held at the front of the bore only, and runout and clamping force both suffer. For finishing tools, choose the collet whose nominal bore matches the shank.

Fitting it to the nut

An ER nut carries an eccentric ring that pulls the collet out of the taper when the nut is loosened. The collet is clicked into that ring before the nut goes onto the chuck. Dropped loose into the chuck and pushed home by the nut, it seats at an angle, and the collet and nut are damaged.

The nut is then tightened with a wrench to the torque the maker gives for the size. Kawacut supplies 6 ER nuts and wrenches.

When to retire one

A collet wears where it works. Look for fretting marks on the taper and for burrs or chips lodged in the slots. A collet that stays partly closed after the nut is released, or a tool that slips under load, is past its life.

The dependable approach is a schedule set by clamping cycles or months of use, with a runout check on the indicator at each tool change for the tools that matter most.

Have your collets and chucks checked at the machine.Book an engineer visit

In this article

Next in the journalMatching a live centre’s Morse taper to the job
Kawacut

Some assembly required.

Scroll to build a BT40 collet chuck.

01 / 09

BT40 taper

7:24 steep taper. The spindle grips here.

02 / 09

Flange

The V-groove is where the tool changer takes hold.

03 / 09

Drive keys

One each side, so the spindle can turn it.

04 / 09

Pull stud

The drawbar pulls on this. Hard.

05 / 09

ER nose

The body that carries the collet.

06 / 09

Marking

Name on the side, so the setter knows what it is.

07 / 09

ER collet

Slotted from both ends, so it closes evenly on the shank.

08 / 09

End mill

The part that actually does the cutting.

09 / 09

Clamping nut

Torqued down. One BT40 ER collet chuck.

Lol, good try!

Go check the website out on a desktop.

kawacut.com