Kawacut
Request a quote
Workholding2 min read

Matching a live centre’s Morse taper to the job

A tailstock centre supports the free end of a long workpiece so that it does not deflect under the cut. Choosing one starts with the taper in the tailstock quill, then the kind of head and the duty it will see.

The taper

Most lathe tailstocks take a Morse taper, numbered from MT0 to MT7. The taper is close to 1 in 20, shallow enough to hold by friction alone, so the centre stays put without a drawbar. The shank of the centre must match the quill: an MT4 quill takes an MT4 centre. A smaller centre can go into a larger quill through a reducing sleeve; the reverse is not possible.

Both tapers should be wiped clean before the centre goes in. A chip on the taper tilts the point and puts the work off centre.

Revolving or fixed

A revolving centre runs on bearings and turns with the work, which suits turning at speed. Kawacut lists 16 revolving centres, MT1 to MT6, in precision, high-speed, heavy-duty and double-point versions.

A fixed centre has no bearings. The point is solid, so it is stiff and accurate, and it suits grinding and low-speed work. It needs grease at the point to stop it running hot. There are 8 fixed centres in the catalogue, MT2 to MT6.

Pipe and hollow work

An umbrella head is a wide cone that centres in the bore of a pipe or tube, where a pointed centre has nothing to locate on. Kawacut lists 22 umbrella live centres, MT2 to MT6, with heads sized to the bore.

Send the tailstock details for a centre to suit.Book an engineer visit

In this article

Next in the journalPull studs and drawbars, and the case for checking both
Kawacut

Some assembly required.

Scroll to build a BT40 collet chuck.

01 / 09

BT40 taper

7:24 steep taper. The spindle grips here.

02 / 09

Flange

The V-groove is where the tool changer takes hold.

03 / 09

Drive keys

One each side, so the spindle can turn it.

04 / 09

Pull stud

The drawbar pulls on this. Hard.

05 / 09

ER nose

The body that carries the collet.

06 / 09

Marking

Name on the side, so the setter knows what it is.

07 / 09

ER collet

Slotted from both ends, so it closes evenly on the shank.

08 / 09

End mill

The part that actually does the cutting.

09 / 09

Clamping nut

Torqued down. One BT40 ER collet chuck.

Lol, good try!

Go check the website out on a desktop.

kawacut.com